Tag Archives: GNS3

Configuring DMVPN Phase 3 Dual Hub

This post details the configuration on how to configure a DMVPN Phase 3 VPN in a Dual Hub Single Cloud. I previously wrote a post on configuring DMVPN Phase 2, refer to this post for more detailed information on configuring DMVPN.

As per most previous posts GNS3 was used to lab the configuration. I had to use the Advanced Security IOS image “c7200-advsecurityk9-mz.152-4.M7” instead of my normal Advanced IP Services IOS image “c7200-advipservicesk9-mz.152-4.S4” because that version does not support NHRP redirect required for DMVPN Phase 3. The error received when configuring NHRP redirect is: % NHRP-WARNING: ‘ip nhrp redirect’ failed to initialise.

This post covers the following:

  • Front Door VRF
  • Crypto Keyring
  • Dual DMVPN Hub configuration
  • DMVPN Spoke configuration
  • DMVPN NHS Clustering (dual active Hubs and Active/Standby Hub)
  • DMVPN Phase 3

The router default ISAKMP Policy, IPSec Transform Set and IPSec Profile were used and therefore not covered in this post. This previous post covers ISAKMP and IPSec Policy/Profile creation.

The lab scenario has 6 x Cisco IOS 15.2(4) routers as represented in the diagram below.


Continue reading Configuring DMVPN Phase 3 Dual Hub

Advertisements

Configuring IKEv2 Site-to-Site VPN on Cisco ASA

This blog post provides the simple configuration information to setup a Site-to-Site VPN between two Cisco ASA firewalls using the IKEv2 protocol.

The following lab scenario was setup in GNS3 using the following images:

  • Cisco ASAv version 9.5(2)
  • Cisco IOS version 15.2(4)

A VPN will be setup between the 2 Cisco ASA firewalls (ASAv-1 and ASAv-2). The 2 routers (R1 and R2) will act as hosts in the local networks in order to generate traffic to initiate the VPN tunnel on demand.
Continue reading Configuring IKEv2 Site-to-Site VPN on Cisco ASA

Configuring Cisco ASAv in GNS3

I was looking for a new convenient lab solution to run on natively on my PC rather than fire up my noisy dedicated HP Proliant Lab server, in order to use the Cisco ASAv. I’ve used GNS3 for IOS devices regularly but never had the chance to use the ASAv. This blog post details the configuration steps I took in order to configure Cisco ASAv with GNS3.
Continue reading Configuring Cisco ASAv in GNS3